Down Pressure Kit
Assembly Instructions
RTA25, RTR25 & RTA35 Series Rotary Tillers
Manual No. 311-134M
Before You Start
Assembly Instructions
Tools required:
• Safety glasses
• Work gloves
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
• 9/16" box end or open end wrench
Refer to Figure 1:
1. Remove wire lock pin (#5).
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
2. Rotate bottom of spring rod (#1) back.
3. Slide down pressure spring (#2) up the spring rod.
4. Slide locking collar (#3) up spring rod and lightly
tighten 3/8" x 3/4" long bolt (#4).
Your Down Pressure Kit is exclusively designed for your
Land Pride Rotary Tiller. Please read these installation
instructions and your Rotary Tiller Operator’s Manual
thoroughly before beginning. Especially read information
relating to safety concerns. Also included in the
Operator’s Manual is important information on operation,
adjustment, troubleshooting, and maintenance for this
attachment (some manual sections do not apply to all
accessories).
5. Rotate spring rod back to mounting ears on rear
deflector and reinstall wire lock pin.
6. Repeat steps 1 through 5 for other spring rod.
7. Adjust lock collars up or down to achieve desired
amount of down pressure on the rear deflector.
NOTE: The lock collars should be the same height.
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
handy when placing an order.
NOTE: Too much pressure will cause premature
wear on the underneath side of the rear deflector.
Manual Part Numbers:
• RTA 25 Series Operator’s Manual . . . . 311-254M
• RTA 35 Series Operator’s Manual . . . . . 311-254M
• RTR 25 Series Operator’s Manual. . . . . 311-251M
• Parts Manual (All Three Series). . . . . . . .311-251P
General Information
This assembly instructions apply to the following Down
Pressure Kit listed below:
311-162 A
Down Pressure Kit
A detailed listing of parts for this accessory kit is provided
below. Use the list as a checklist to inventory parts
received. Please contact your local Land Pride dealer for
any missing hardware.
Your Kit Includes:
Qua. Part No.
Part Description
2
2
2
311-209D
802-014C
807-005C
SPRING ROD COLLAR RTA25/35
HHCS 3/8-16X3/4 GR5
DOWN PRESSURE SPRING
10364
Down Pressure Kit Assembly
Figure 1
© Copyright 2007
Printed
5/15/07
1
|