Lytecaster® Recessed Downlighting
1000LVNT
Page 1 of 1
5" Aperture Low Voltage MR16 Remote Transformer Frame-In Kit
1
6
Ceiling Opening
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit
Reflector Trims — See Individual Reflector Trim Specification Sheets
Adjustable
1000LVNT
Baffles
Aperture Cone
Pinhole
Elbow
1055LV
1055WHLV
1056LV 1064WDLV
1063LV 1064WDPLV
1064LV
1052LV
1062LV
1064CDLV
Features
Options & Accessories
Mounting Bars:
T-Bar Ceiling Clips:
Plaster Ceiling Ring:
Extra-Thick Ceiling
1. Mounting Frame: .036" (#20 ga.) galvanized steel. Accommodates all
ceilings up to 1" thick; including existing or inaccessible areas. Breakout
section and anchor nails permits installation in existing ceilings from below.
Push-in/twist-out rotoclips hold reflector flush to ceiling.
1964 - 20" set of (2)
1956 - set of (4)
1960 - 7/8" depth for wet plaster ceilings.
1967B - up to 2" thick ceilings.
2. Junction Box: 4" x 3 1/2”x 2", .063" (#14 ga.) galvanized steel. U.L. listed for
maximum of 8 No. 12 ga. 90° C through branch circuit conductors (75° C end
of run). Integral cable clamps permit attachment of nonmetallic Romex® or
armored cable without need of additional connectors.
Mounting Ring:
Remote Transformer:
MR16 Socket Replacement:
Remodeler Anchor Clip:
8608 or 8609
1975A
1985N
3. Mounting Bars: .059" (#16 ga.) galvanized steel. 13" long bars extend
to 27" with integral nailing tabs. Attaches to wood joist without need of
accessories.
Labels
UL (Suitable for Damp Locations), I.B.E.W.
4. Socket Housing: .036" (#20 ga.) galvanized steel.
5. Socket: Field replaceable. Two pin socket, pre-wired with #18 SF1 leads to
junction box.
6. Thermal Protector: Meets NEC and UL requirements. Insulation must be
kept 3" away from fixture sides and wiring compartments and must not be
placed above fixture in a manner which will entrap heat.
7. Transformer: Frame-in Kit is provided without transformer. Transformer
must be provided by others. Lightolier Cat. #8608 or 8609 transformers may
be used. Frame-in Kit is rated at 65VA. Use only 12V A.C. input.
Romex® is a registered Trademark of General Cable Industries Inc.
US Patent No.: 5,045,985
Job Information
Type:
Job Name:
Cat. No.:
Dimming
Lamp(s):
Notes:
Dimming Controls: use only dimmers specifically designed for use with mag-
netic transformers, like Lightolier Onset®, Sunrise® series LV or VA dimmers,
or any Lightolier Controls dimming system. Low voltage fixtures may produce
audible sound when used with dimmers, which may be objectionable in acousti-
cally critical areas.
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
Lightolier is a Philips group brand
|