Guv’nor Plus Suggested Settings
GV-2 Guv’nor Plus
FAT BLUES (Amp: Clean)
CRUNCH (Amp: Clean)
GRUNGE / HARDCORE (Amp: Clean)
SCREAMING SOLO (Amp: Clean)
Owners Manual
WARNING!
5
IMPORTANT Precautions
2
3
4
7
9
Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
From The Chairman
WARNING
I would like to personally thank you for
selecting one of our effects pedals.
Do not expose the apparatus to rain or moisture. Do not expose
the apparatus to dripping or splashing. No objects filled with
liquids should be placed on or near the apparatus. Do not use
this apparatus near water.
For over 40 years the Marshall name has been synonymous with
the greatest guitar tones in music. We have worked hand in hand
with guitarists from all levels throughout the world to maintain
and improve that special ingredient, ‘The Marshall Sound.’
6
8
Clean only with dry cloth.
1
10
Our range of effects pedals gives the opportunity to augment the
classic Marshall tone to add Marshall character to a guitar set-
up.
Changes or modifications not expressly approved by Marshall
Amplification plc could void the user’s authority to operate the
equipment.
All our pedals are made with the same utmost attention to
quality, in both materials and manufacture as our world
renowned amplifiers, cabinets and combos, in order to provide
you with optimum reliability and tone.
I would like to wish you every success with all of your musical
endeavours and also your new Marshall effects pedal, which I am
sure you will find a pleasure to play for many years to come.
11
Yours Sincerely,
Heed all warnings.
Follow all instructions.
Keep these instructions.
European Product Only
1
amount of bass will generally make your tone warmer and thicker
at the bottom end.
Trouble Shooting
4. Deep
This adds an active resonant bass boost to your tone in a way that
can’t be replicated with traditional tone controls and has a similar
effect to the acclaimed JCM2000 “Deep” switch. Increasing the
amount of Deep will add masses of tight bottom end to your tone
giving it real low end resonance and incredible fullness.
WHAT IF
NO
OUTPUT
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
5. DC Input
For input of a 9V DC negative regulated power supply should you
not wish to use batteries.
6. LED
NOISE IN
BYPASS
Indicates when the Guv’nor Plus is in operation.
7. Treble
INDICATOR
LED NOT
ON
Adjusts the high end frequencies in your tone, an increase making
it brighter, sharper and more cutting.
INPUT
LEAD
8. Mid
SOUND TOO
TREBLY OR
FIZZY
Adjusts the middle frequencies in your tone. Adding more middle
will fill out your sound and make it fatter. By reducing the amount
of middle in your tone you will make it thinner and sharper.
Cranking the gain (item 2) up and setting the Mid control to
minimum will deliver “scooped” sounds, ideal for brutal crunch
tones.
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
SOUND TOO
MUSHY OR
BASSY
ꢀ
ꢀ
ꢀ
9. Volume
ꢀ
UNUSUAL
FEEDBACK
Adjusts the volume of the Guv’nor Plus. This allows you to cut or
boost your volume when you switch the pedal on and is ideal for
switching from rhythmn to higher volume solo levels. The Volume
levels of the Guv’nor Plus are greater than previously available on
the original Guv’nor to allow you to push the front end of your
amp harder for even more overdrive.
REDUCE
TREBLE
REDUCE
TREBLE
ꢀ
ꢀ
ꢀ
UNUSUAL
HUM
MOVE AWAY
FROM AMP
10. In Jack
ꢀ
BASS
FEEDBACK
PICKUPS
MAY BE
VIBRATING
This is the input jack, for connection directly from your guitar or to
another effects pedal if you are linking pedals together.
11. Foot Switch
For switching the Guv’nor Plus on and off.
4
5
Battery Replacement
1. To replace the battery, open
the easily accessed coin screw
battery cover plate by
loosening screw as shown,
then disconnect the battery
connector lead.
2. Use PP3 or equivalent battery
(for improved battery life use
alkaline type)
3. Always ensure that the battery
is removed when the pedal is
not in use for long periods.
4. Dispose of old battery in a
safe place.
Technical Specification
Power: 9V DC Centre Negative Regulated
Current Draw: 9mA
Controls: Pedal Switch, Gain, Bass, Treble, Volume, Deep & Mid.
Switches: On/Off Switch
Indicators: On/Off LED
Jacks: Input/Output ‘Jacksockets’
Input Impedance: 1MΩ
Output Load Impedance: max 1kΩ
Dimensions: 120mm x 65mm x 55mm
Weight: 510 grammes
d from Www.Somanuals.com. All Manuals Search And D
6
|