KIT FEATURES
5
ISO-DIN
head unit
provisions
Incorporates
factory climate
controls into
installation
Passenger Air Bag
99-5717
INSTALLATION
INSTRUCTIONS
Fig. A
On/Off Light
Incorporated
(located under
the rear deck)
Fig. B
KIT COMPONENTS
APPLICATIONS
Open the trunk, remove (4) pop-clips from the driver's side trunk liner and remove the liner.
(see Fig. A). Locate the factory tuner on the wall of the trunk and disconnect the speaker and
antenna plugs (it is NOT necessary to remove the tuner). (see Fig. B). Plug the 70-5715 into
the unit speaker plug and the antenna extension lead into the unit antenna plug. Slide the
extension harness through the space in the back seat between the seat back and seat bottom.
Unclip the rocker trim, tuck the extension harness under the carpet and stretch the harness to
the back of the dash. (Replace the rocker trim when completed). Splice the speaker leads on
the extension harness into the rear of the aftermarket head unit. Plug the factory wiring
harnesses into the switch connectors (previously mounted in step #2) and audio connectors
on the back of theIntegratedMountingKit.
CAR
FORD
PAGE
Taurus 2004-2007..................................................1-3
MERCURY
Sable 2004-2007.....................................................1-3
Integrated
Mounting Kit
ISO Faceplate
6
Extension
s
(2) #8 x 3/8"
Phillips Pan-head Screws
TOOLS REQUIRED
86-5618 - Head unit
removal keys
Re-connect the battery terminal and test the unit, climate controls and rear defroster for proper
operation. Snap the IntegratedMountingKit assembly into the sub-dash.
1-800-221-0932
Torx-head screwdriver
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 03/08/07
INST99-5717
3
|