KIT FEATURES
5
6
A
B
Shaft and
DIN unit
provisions
"A"
99-6540
INSTALLATION
INSTRUCTIONS
C
D
KIT COMPONENTS
ing
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
APPLICATIONS
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Locate the upper dash tab in the sub-dash and
bend the tab down.("A")
CAR
DODGE
PAGE
Faceplate
Van (full size) 1990-97.............................................1-3
7
(3) 3/8" Phillips
Screws
TOOLS REQUIRED
Phillips screwdriver
Cutting tool
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit
assembly to the sub-dash with (2) screws. Place the Faceplate into the dash trim bezel and
mount with(3) 3/8" Phillips screwssupplied.
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Drill
rev. 100103
3
|