Philips Portable DVD Player PET831
wk0745
Quick start guide
1
2
3
Enjoy
Charge
Connect to TV
1
5
6
3
1 Connect the set to the TV as shown.
2 Select an appropriate input or source on the TV.
You can consult the user’s guide of your TV. (If
your TV does not have Audio andVideo inputs,
you will need to purchase a RF modulator. Please
consult your dealer for more information.)
2
1 Switch ON the set.
2 The GREEN light comes on.
3 Slide the disc into the slot on the right side
of the player with the label side of the disc
facing the front of the player.
1 Switch OFF the set.
2 Connect the supplied adaptor to the set
and the AC outlet.
TIP For better video quality, please use COMP.
OUT connection as shown below.
4 The set will automatically start to play.
5 Use the control keys on the set or the
remote control.
3 The RED light comes on.
4 The battery pack will be fully charged in
approximately 4 hours.When the RED light
goes off, it means that the battery pack is
fully charged.
6 To eject the disc, press 9 / twice.
IMPORTANT Do not load any 8-cm mini
DVD discs into the player.The DVD player
does not play mini DVD discs. If the disc gets
stuck inside the player, press 9 / twice to
eject the disc.Try the following steps if the
disc remains stuck inside the player.
1 Power off and then power on the player.
Press 9 / to eject the disc.
2 If this does not work, hold the player with
the slot facing down, gently shake the
player until the disc comes out.
Green
Y
Blue
PB
TIP Your battery will continue to charge while
the player is in use. However, the RED light
will not appear and it will take approximately 8
hours to fully charge the battery pack.
Red
PR
|