Everpure Water System WS 30 User Manual

EV9980-10  
WS-Series  
Water Conditioning for Commercial and Light Industrial  
Applications Available in Single Tank System with 1" Porting  
B E N E F I T S  
Hardness removal of 30,000 to 45,000grains at  
flow rates up to 12 gallons per minute continuous  
WS-30: EV9980-10  
Meter initiated regeneration minimizes salt, water  
and electrical costs  
Advanced user-friendly controls incorporates  
time-tested hydraulically balanced piston, seal  
and spacer design to pilot service flow and  
regeneration  
Large capacity brine tank maximizes time  
between refills  
Fiberglass reinforced resin vessels with NSF  
approved polyethylene liners eliminate worries  
about corrosion  
Single tank design for simplicity, economy and  
space savings  
5-cycle control delivers controlled upflow  
backwash, downflow brining and slow rinse, rapid  
rinse, timed brine refill and downflow service  
A P P L I C A T I O N / S I Z I N G  
I N S T A L L A T I O N T I P S  
O P E R A T I O N T I P S  
Locate equipment on a smooth, level surface  
Maintain an air-gap at the end of the drain line  
Check for softened water each time salt is added,  
by using soap of hardness test kit  
Reverse Osmosis Pre-treatment  
Espresso Machines  
Use a good quality grade of salt - Solar or pellet  
are preferred  
Secure drain line directly over floor drain or stand  
pipe  
Warewashing  
Check the salt level on a regular basis  
Laundry-Linen & Uniform  
Boiler Scale Control  
When connecting a water heater, install a check  
valve on the soft water piping to prevent hot  
water back-up  
Maintain a minimum Salt depth of 6" to ensure a  
proper regeneration  
Water Heater Scale Protection/Reduction  
General Housekeeping  
When sweating/installing copper piping, protect  
the control valve from excessive heat  
On iron bearing waters, use a salt that contains an  
iron "fighting" additive, or use a resin cleaner on  
a regular basis  
Check local codes for additional equipment that  
may be required, such as backflow prevention  
devices (I.e., RPZ)  
Check the water level in the brine tank. If  
abnormally high - refer to IO guide for  
troubleshooting information  
 

Cooper Lighting Marine Safety Devices ELPS502 User Manual
Craftsman Portable Generator 919679500 User Manual
Cuisinart Coffeemaker DCC 3200 User Manual
Dimension One Spas Hot Tub 01510 1030 User Manual
Directed Audio Stereo Equalizer Model 6500 User Manual
Dixon Lawn Mower 42BF User Manual
Extron electronic Network Card P N 26 448 01 User Manual
GBC Laminator ORCA IV User Manual
Gefen Cable Box GEF HDMI13 2 3GSDI User Manual
GE Monogram Drill ZGG36N31YSS36 User Manual